Directions:
-Prep your natural lashes by removing makeup/excess oils to maximize wear time.
-Curl your natural lashes with a lash curler, then brush on a thin, even coat of bond under your natural lashes (a little goes a long way).
-Brush only in one direction, so lashes don’t stick to each other (near root to midpoint of lash).
-For thinner lashes, apply two coats.
-For thick lashes, apply one coat.
-Wait 20 to 30 seconds for the bond to become tacky.
-Using the lash grab, gently apply each cluster underneath the base of your natural lashes, slightly away from your waterline to avoid possible irritation.
-Once you’re satisfied with your application, use the lash grab to merge both the band and the strands of each segment with your natural lashes.
-To remove any residue, apply a thin coat of seal above and below lashes and wherever you feel excess stickiness.
How to remove:
-Apply bond remover to a cotton ball.
-Place pad over your eyes and hold for 20 seconds.
-Gently wipe off lash clusters and bond.
-Repeat, if necessary, to ensure all residue is removed.
Precautions:
-Do not use it if the eye is injured, infected, or irritated.
-Consult a physician promptly if damage occurs.
-Do not get bond or seal into eyes; in the event of direct contact, rinse with cool water.
-Keep out of reach of children.
|